Jeff Rowland Jeff Rowland Integrated amplifier Continuum S2 with DAC option

Pristine fantastic sounding Jeff Rowland Continuum S2 integrated amp with the optional DAC included .
Very slightly used , super carefull owner . Complete with all accessories and original box and cords .
Can drive any speaker load effortlessly , sounds dynamic but warm with a big sounstage .
Selling because I barely have had time to use it this past year .

Featuring enhanced sonic performance and flexibility, the new Rowland Continuum Series 2 integrated amplifier delivers stunning dynamic realism and expressive refinement through advanced topologies. Continuum S2 integrates the new Capri S2 preamplification circuit, input/output, and control features with an innovative 400 watt power amplification stage into a single chassis.

The amplifier delivers the trademark Rowland musicality, resolution, and unfailing authority to the most refined audio environments: challenge Continuum S2 to the extreme dynamics of high-resolution digital sources and the power requirements of large bi-wired speakers. Apply it to the complex loads of electrostatic panels in analog rigs. Admire its exceptional realism driving single-wired studio monitors in a sophisticated multi-media system.

The elegance of Continuum S2’s ergonomic console emerges from a solid block of aircraft-grade aluminum. Discover the impressive complement of standard input/output interfaces. Enhance its flexibility through the optional DAC card .

Features :


Understated elegance

Integrated 400W balanced amplifier design housed inside an elegant, ultra-low resonance, structurally rigid chassis that is precision-machined from solid blocks of aircraft grade 6061-T6 aluminum that is completely sealed for trouble-free operation and high RF and EMI isolation.
Power supply efficiency

Regulated, high speed, vanishingly quiet switch mode power supplies (SMPS) ensure consistent performance under all operating conditions.
Leading preamplification

Advanced linestage circuit based on the sophisticated topology of the Capri 2 preamplifier yielding and incredibly refined musical experience from a compact and efficient system.
Thin Film Resistors

All resistors are low noise, 0.1% thin-film type for extremely low thermal noise which complement the low-noise characteristics of the active circuitry.
Four Layer Circuit Board

All circuitry is populated on one side of a 4 layer circuit board to allow for continuous, unbroken, low impedance ground and power supply distribution planes. Care was taken to minimize signal path lengths and components sizes.
Green power

Twin ultra- high efficiency power conversion modules yield 400 Watts per channel into 8 Ohms, doubling over 4 Ohms, and a peak current of 40 Amps.
Enhanced authority

Specifications
Output Power @ 8 ohms Continuous RMS 400 watts, both channels driven
Output Power @ 4 ohms Continuous RMS 800 watts, both channels driven
Frequency Response 5 Hz – 70 kHz, -3 dB @ 8 ohms
THD & Noise < 0.05%, 20 Hz – 20 kHz
Inputs 2 pair Balanced (XLR), 2 pair Unbalanced (RCA) / 1 pair Unbalanced (RCA), Unity Gain (Bypass)
Outputs 1 pair Balanced (XLR), 1 pair Unbalanced (RCA) / 1 pair CE-Approved Speaker Wire Clamp
Power Supply Switch Mode (SMPS) and universal AC input voltage
Amplifier Weight 35 lbs / 15.9 kg
Amplifier Dimensions (H) x (W) x (D) 5.3″ x 15.5” x 15.0” (135mm x 394mm x 380mm)